لمینت MKP
1402-06-04
Menu
E7-01 Duplex model memory setup error, memory not-detected error
The memory is not set properly or the memory capacity is not set to the duplex setup (6M copyir.com. Cancel method: Set SIM 26-39 code number to 2.
E7-02 HSYNC not detected.
LSU (laser diode, reception element, APC circuit copyir.com trouble LSU drive circuit (ASIC copyir.com trouble
E7-10 CCD black level trouble
CCD drive circuit (CCD PWB, ASIC, harness copyir.com trouble
E7-11 CCD white level trouble
CCD drive circuit (CCD PWB, ASIC harness copyir.com trouble Copy lamp lighting trouble (Copy lamp, inverter PWB copyir.com
E7-12 Shading trouble (White correction copyir.com
Dirt on white plate for scanning white level
E7-16 Laser output trouble
LSU (laser diode, reception element, APC circuit copyir.com trouble LSU drive circuit (ASIC copyir.com trouble
F5-02 Copy lamp disconnection trouble
Copy lamp or copy lamp drive circuit (inverter PWB copyir.com trouble Copy lamp disconnection
H2-00 Thermistor open detection
The fusing thermistor is open.
H3-00 Heat roller abnormally high temperature
The fusing temperature rises above 240°C.
H4-00 Heat roller abnormally low temperature
The fusing temperature does not reach 185°C within 27 sec of turning on the power, or the fusing temperature keeps at 140°C.
L1-00 Feeding is not completed within the specified time after starting feeding. (The scan head locking switch is locked copyir.com
The white area and the black marking on the shading plate are used to obtain the difference in the CCD level values for judgment of lock. When the difference in the levels of which and black is small, it is judged that the black mark could not be scanned by lock and the trouble code “L1” is displayed.
L3-00 Return is not completed within the specified time.
When the mirror base is returned for the specified time (6 sec copyir.com in mirror initializing after turning on the power, the mirror home position sensor (MHPS copyir.com does not turn ON. Or when the mirror base is returned for the specified time (about 6 sec copyir.com after start of copy return, the mirror home position sensor (MHPS copyir.com does not turn ON.
L4-01 Main motor lock
When the main motor encoder pulse is not detected for 100 msec.
L6-10 Polygon motor lock
The lock signal (specified rpm signal copyir.com does not return within a certain time (about 20 sec copyir.com from starting the polygon motor rotation
U2-01 Counter sum check error
When the counter check sum value stored in the EEPROM is abnormal.
U2-04 EEPROM serial communication error
When a communication trouble occurs with the EEPROM.
اشتراک گذاری در:
در خبرنامه ما عضو شوید
تمامی حقوق این سایت متعلق به کپی ایران بوده و هر گونه بهرهبرداری از آن مستلزم کسب اجازه میباشد.