کیو سرا میتا fs1325mfp

کیو سرا میتا fs1325mfp

0030    FAX Board System Error
Cannot communicate with the modem when activated     copyir.com    Defective FAX control PWB     copyir.com
0100    Backup memory read/write error(NOR)
Flash returns an abnormal status     copyir.com    Defective flash memory     copyir.com Defective main PWB     copyir.com
0120    MAC address data error
For data in which the MAC address is invalid     copyir.com    Defective flash memory     copyir.com
0190    Backup memory error (engine)
Unable to read the main PWB IC     copyir.com    Defective flash memory     copyir.com Defective main PWB     copyir.com
0630    Scan DMA error
Unable to transfer DMA     copyir.com    Defective main PWB     copyir.com
2000    Main motor error
Pulse is not detected after 1000msec     copyir.com Motor won’t stabilize after 300msec     copyir.com    Defective connector cable or poor contact in the connector Defective drive transmission system of motor     copyir.com Defective motor     copyir.com Defective main PWB     copyir.com
3100    Scanner Carriage Error
The HP sensor won’t be opened when it is driven in the scan direction for 37     copyir.com44 mm (*1) at the initial scanning when the HP sensor is cut off     copyir.com The HP sensor won’t be cut off when it is driven in the return direction for 320     copyir.com44mm (*2) at the initial scanning when the HP sensor is open     copyir.com    Defective connector cable or poor contact in the connector     copyir.com Defective home position sensor     copyir.com Defective scanner motor     copyir.com Defective main PWB     copyir.com
3300    AGC Error
The resultant AGC fell outside the range of allowance     copyir.com    Defective connector cable or poor contact in the connector     copyir.com CIS sensor     copyir.com Defective main PWB     copyir.com
3500    Scan ASIC Error
The scan ASIC has been inoperative     copyir.com    Defective main PWB     copyir.com
4000    Polygon motor synchronize error
Polygon motor is not stabilized within 15 s since the motor is activated     copyir.com After polygon motor is stabilized, the ready signal is not detected for 7 s continuously     copyir.com    Defective connector cable or poor contact in the connector     copyir.com Defective polygon motor     copyir.com Defective main PWB     copyir.com
4200    BD stability error
The BD signal is not detected for 1000 ms after processing the compulsion lighting     copyir.com At the interrupt in VSYNC, the BD error is detected continuously for 10 times in 400 ms intervals     copyir.com    Defective connector cable or poor contact in the connector     copyir.com Defective APC PWB     copyir.com Defective main PWB     copyir.com
6000    Broken fuser heater
The temperature does not reach 100° C/212 °F after the fuser heater lamp has been turned on continuously for 30 s     copyir.com At the time of 20 degrees or less from specified temperature, the fuser temperature does not rise by 2 degrees or more after the fuser heater lamp has been turned on continuously for 8 s     copyir.com(during ready or during print)    Defective connector cable or poor contact in the connector     copyir.com Fuser thermostat triggered     copyir.com Defective fuser heater     copyir.com Defective main PWB     copyir.com
6020    Abnormally high fuser thermistor temperature
Fuser thermistor detects a temperature higher than 210°C/410°F for 3 s    Deformed connector pin     copyir.com Shorted fuser thermistor     copyir.com Defective power source PWB     copyir.com Defective main PWB     copyir.com
6030    Broken fuser thermistor wire
Average input AD given by the thermistor is less than 2 for 300msec     copyir.com    Defective connector cable or poor contact in the connector     copyir.com Broken fuser thermistor wire     copyir.com Fuser thermostat triggered     copyir.com Defective main PWB     copyir.com
6400    Fixing control zero cross signal error
The ZCROSS signal does not reach the main PWB for more than 2 s     copyir.com    Defective connector cable or poor contact in the connector     copyir.com Defective power source PWB     copyir.com Defective main PWB     copyir.com
F000    Communication Error between Main PCB and Panel PCB
Communication failure during the start-up or operation     copyir.com * : Only 3 in 1 25/26 ppm model, 4 in 1 20/21, 25/26 ppm model    Defective main PWB     copyir.com Defective operation PWB     copyir.com
F020    RAM R/W error
The average AD value of the sensor input is smaller than 2 during SLP_RLY is off and 300 ms     copyir.com    Defective main PWB     copyir.com
F040    Communication Error between Main PCB and Engine PCB
Communication is failed between the controller and the engine     copyir.com    Defective main PWB     copyir.com
F050    No Engine Main Program
Engine program failure     copyir.com    Defective engine software     copyir.com Defective main PWB     copyir.com