کیو سرا میتا fs1600

کیو سرا میتا fs1600

–    Paper feed unit open    The cassette is open in the option paper feeder     copyir.com
–    Top cover Open    Interlock (SW2 on KP-373/418 [AC] board) is open     copyir.com
–    Opt     copyir.com feeder 1 (2) rear cover Open    The rear cover of the frist (second) option feeder is open     copyir.com
–    Developer unit connection error    The developer connector is loose or not connected     copyir.com
–    Replace Toner kit TK-12 feeder     copyir.com    Toner in the developer has been exhausted and the toner concentration in the developing powder is not restorable     copyir.com The printer does not operate when this message is displayed     copyir.com’c
–    Missing Toner container    Toner container is not installed     copyir.com
–    Paper jam    Paper is jammed inside the printer     copyir.com Depending on the part of the printer at which jam has occurred, one of the feed or stack indicators flashes; Ready indicator flashes; and ATTENTION lights     copyir.com After the jam is removed, the printer automatically prints the same page again unless the paper was caught before or in the fuser unit     copyir.com
–    Remove manual feed paper    Paper exists on the manual feed tray while the paper source is envelope feeder     copyir.com
–    IC-CARD error insert again    The IC card is accidentally removed while rereading     copyir.com
–    Insert the same IC CARD    The wrong IC card was inserted, following the IC-CARD error/insert again message     copyir.com
–    Memory overflow      copyir.com     copyir.com Press ON LINE    The total amount of the data received by the printer exceeds the printer’s internal memory     copyir.com
–    Print overrun      copyir.com     copyir.com Press ON LINE    The data transferred to the printer was too complex to print on a page     copyir.com
–    Add paper    The paper cassette is empty or not mounted, or manual feed mode is activated but no paper is present in the manual feed tray     copyir.com
–    Warning low toner TK-12    The toner supply in the developer is being exhausted     copyir.com The printer will stop printing after several ten pages of printing     copyir.com
–    Warning Short memory    The printer’s internal memory is running out due to too many macros and fonts downloaded     copyir.com
E0    Call service person E0    Engine communication error     copyir.com The engine controller won’t respond to the command sent by the system via the dual port RAM in approx     copyir.com 1     copyir.com2 seconds     copyir.com
E1    Call service person E1    Main Motor Error     copyir.com The pulse signal is not detected     copyir.com
E4    Call service person E4    Fuser Heater Error     copyir.com
E5    Call service person E5    Eraser Error     copyir.com The eraser current is less than 15mA (normally 65 mA)     copyir.com
E6    Call service person E6    Engine ROM check sum error     copyir.com
E9    Call service person E9    Toner Motor Error     copyir.com The toner motor current is 120 mA or more for one second (normally 30 mA)     copyir.com
EE      copyir.com     copyir.com     copyir.com EF    Call service person EE/EF    Drum Heater Error/Total Page Counter Error     copyir.com
F1    Call service person F1    System Checksum Error     copyir.com An error is detected in the controller     copyir.com The Ready-symbol and ON LINE indicators go off; and ATTENTION lights     copyir.com The printer does not operate when this message is displayed     copyir.com
F2    Call service person F2    Main RAM Error     copyir.com